sarahjoyce
New Member
May the mass times acceleration be with you.
Posts: 9
|
Post by sarahjoyce on May 14, 2015 18:35:20 GMT
Hi Adam, Conor and Michael,
I just viewed the mini updates email and saw that our rig is complete - thank you! I also had a look at the L293 Motor Driver Guide, as per the email recommendation, and I'm able to open the PDF tutorial, but not the Testcode. I'm just wondering would the Arduino Servo Sweep code that we were looking at last week (included below) be similar, if not the same?
Thanks, Sarah
#include <Servo.h>
Servo myservo; // create servo object to control a servo // twelve servo objects can be created on most boards
int pos = 0; // variable to store the servo position
void setup() { myservo.attach(9); // attaches the servo on pin 9 to the servo object }
void loop() { for(pos = 0; pos <= 180; pos += 1) // goes from 0 degrees to 180 degrees { // in steps of 1 degree myservo.write(pos); // tell servo to go to position in variable 'pos' delay(15); // waits 15ms for the servo to reach the position } for(pos = 180; pos>=0; pos-=1) // goes from 180 degrees to 0 degrees { myservo.write(pos); // tell servo to go to position in variable 'pos' delay(15); // waits 15ms for the servo to reach the position } }
|
|